Energy saving retrofit LED control


Energy saving retrofit LED control with MW

The AVL-4501 is a patented smart light control system
Provides power saving for high power retrofit LED lamp
Activate LED lamp when movement detected
On board photo cell measures the light level at environment
Main control board with self test features
Motion detector connected to the switching circuitry
Movement detection by microwave (MW) Doppler Effect detector
The system is for outdoor build in IP-65 housing
Most used to control large retrofit LED lamp at high saving mode
New LED lamps replace old incandescent lamps (high power consumers)
The AVL-4501 is compatible retrofit 24V LED light lamp
Other LED lamp does not fit.
The AVL-4501 is configured to work with dedicated power supply
The AVL-4501 turn on the LED lamp automatically when light is low
At low light DC power delivered to the lamp is full (100%)
At low light the control start counting 6 hours

Saving great power

After 6 hours the supplied DC power decrease to 40% for saving
After 6 hours if motion detected it turns on the light automatically to supply full power
during 3 minutes, than LED lamp power returns to half (40-50%).
As the light level is high (at sun rise) the control turns the light off.
DIP-Switches set most parameters

SKU: AVL-4501

Energy saving retrofit LED control with MW

The AVL-4501 is a patented smart light control system
Provides power saving for high power retrofit LED lamp
Activate LED lamp when movement detected
On board photo cell measures the light level at environment
Main control board with self test features
Motion detector connected to the switching circuitry
Movement detection by microwave (MW) Doppler Effect detector
The system is for outdoor build in IP-65 housing
Most used to control large retrofit LED lamp at high saving mode
New LED lamps replace old incandescent lamps (high power consumers)
The AVL-4501 is compatible retrofit 24V LED light lamp
Other LED lamp does not fit.
The AVL-4501 is configured to work with dedicated power supply
The AVL-4501 turn on the LED lamp automatically when light is low
At low light DC power delivered to the lamp is full (100%)
At low light the control start counting 6 hours

Saving great power

After 6 hours the supplied DC power decrease to 40% for saving
After 6 hours if motion detected it turns on the light automatically to supply full power
during 3 minutes, than LED lamp power returns to half (40-50%).
As the light level is high (at sun rise) the control turns the light off.
DIP-Switches set most parameters

Compared to PIR energy switch

Penetrate mineral objects
Not effected by environment temperature
Temperature does not reduce detector range
Can be installed under mineral ceiling and walls

Main Features

High performance LED lamp control box
Advanced microwave included
Enclosed in outdoor housing
Compatible with retrofit LED lamp

Technical

Operation voltage: 24V or 48V DC is optional
Power consumption: 50 mA (standby), 47 mA (detection)
Detection range: 14m at 2.5 meters high, environment 20ºC
Detection settings: Resistor trimmer
Operation frequency: 10.525 GHz. Optional: 21.125 GHz
Indicators: Solid state lamp LED, Blue, Green and Red
Load power: Dry contacts relay 10A @ 24V. N.C. & N.O
Time Delay: Electronic up to 24 hours
Detection angle: 120 degree
Installation height: 1.8m to 4m
Detection Motion Speed: 0.6 to 1.5 m/s
RFI Protection: 30V/m @ 10–1000 MHz
EMI Protection: 50KV @ 1 mS lightning or surge
Operating Temperature: -20 to +55ºC (-4 to 131ºF)
Relative humidity: Less than 93% RH
Dimensions: L=192, W=87, H=61 mm (7.55 x 3.4 x 2.4″)

Accessibility Toolbar